TSC barcode printer some typical problems.

2024-07-11 23:35
3

TSC barcode printer customers may encounter some typical problems.


1. Print quality problem

Problem: The printed label is fuzzy, missed or the bar code is not clear.


Answer:


Cause: It may be related to dirty print head, wear, improper adjustment, poor label quality, or incorrect printer Settings.

Workaround: Clean the print head regularly, make sure to use high-quality print media, and adjust printer Settings as needed, such as print speed and print density.

2. Paper feeding problem

Problem: Paper gets stuck or doesn't feed properly.


Answer:


Cause: It may be an inappropriate paper type, incorrect placement, debris inside the printer, or sensor failure.

Workaround: Use the right type and size of paper, make sure the paper is properly loaded, and clean the inside of the printer regularly. If the problem persists, check that the sensor is working properly.

3. Connection and communication problems

Problem: The printer cannot connect to a computer or other device.


Answer:


Cause: Loose cable, driver problem, or equipment failure.

Solution: Check that the cable is firmly connected, and update or reinstall the driver to ensure that the device works properly.

4. The machine is loud and difficult to cover

Problem: The machine is loud during the printing process, and the cover of the printer is difficult to cover.


Answer:


Reason: the ribbon reel is inverted.

Solution: Check that the ribbon reel is properly installed and reinstall it if necessary.

5. No response or no content can be printed

Problem: The printer paper is normal, but the content cannot be printed or the machine does not respond.


Answer:


Cause: The machine may not receive data, the ribbon is inverted, or the driver problem.

Solution: Check the data interface and connection line to ensure that the data line is correctly connected; Check whether the ribbon is inverted; Update or reinstall the driver.

6. Sensor problem

Problem: The red light is on during the printing process, and the sensor does not detect the paper or ribbon.


Answer:


Solution: First turn off the printer power, hold down the PAUSE key to start, and release the hand after the printer produces paper, and observe whether the printer has a retraction. If not, repeat the above or hold down the PAUSE and FEED keys at the same time to initialize the machine.

7. Software problems

Problem: The print content is incomplete, garbled, or the software cannot typeset.


Answer:


Cause: Software printing program error, improper layout Settings or computer system problems.

Solution: Restart the printing program, create a new label and reformat; Check and update software and driver versions; Reinstall the software or operating system if necessary.

8. Other common problems

The ribbon does not rewind during the printing process: it may be that the operator turns on the machine without installing the ribbon, and the default is thermal printing. The solution is to turn off the machine first, properly install the ribbon and label paper, and then turn on the machine.

Print content offset: Possible sensor error or improper label setting. Adjust the sensor position or label Settings based on the offset.

When printing, one side is clear and the other is blurred: it may be an imbalance of print head pressure. Adjust the pressure screw on the print head to balance the pressure.

Please note that the above questions and answers are based on the summary and summary of common faults of TSC barcode printers. In the actual use process, the specific problems that customers may encounter may vary depending on the printer model, the use environment and the mode of operation. Therefore, it is recommended to refer to the printer's user manual or contact technical support for more specific guidance when troubleshooting.