How to properly install all resin carbon tape?

The installation of all resin carbon tape is a process that requires careful operation, and the following installation steps are summarized according to professional sources and practical operating experience:

1. Preparation

Confirm the reinforcement position: Select the appropriate length and width of the all-resin carbon strip as required.

Prepare tools: Prepare necessary tools, such as scrapers, shovels, sandpaper, grinding wheels, solvents, or water, for cleaning and treating the surface of steel pipes or substrates.

Mixed epoxy resin: The epoxy resin material is mixed in proportion for use.

2. Cleaning and disposal work

Clean the surface: use a scraper, shovel and other tools to remove the adhesion, rust and old paint on the surface of the substrate.

Polish the surface: smooth the surface of the substrate with sandpaper, grinding wheel and other tools to ensure that the surface is free of rust, oil and impurities.

Clean the surface: Clean the surface with solvent or water, remove stains and dust on the surface, and dry the surface.

3. Install all resin carbon belt

Primer: Brush the mixed epoxy resin material on the surface of the substrate as the primer. This step can enhance the adhesion of the all-resin carbon strip to the substrate.

Bonded carbon tape: the pre-cut all-resin carbon tape is wound on the substrate from one end, slowly wound and pulled tight to ensure that the carbon tape is fully bonded to the substrate. During the winding process, it should be noted that a certain interval should be maintained between the carbon bands, and the carbon fiber and epoxy resin should be uniformly bonded on the surface of the substrate and compacted.

Fixed carbon belt: After all the resin carbon belt is fixed, according to the construction requirements, the edge of the carbon belt is fixed on the substrate with autotrophic screws and tightened.

Clean the surface: Remove excess epoxy material and impurities.

Wait for drying: Wait for all the epoxy resin material to dry, the installation of the all-resin carbon belt is completed.

4. Precautions

Safe operation: During the installation process, pay attention to safe operation to avoid contact with skin and eyes of materials such as epoxy resin.

Environment requirements: Keep the installation environment dry and ventilated. Do not install in a humid or harsh environment.

Quality inspection: After the installation is completed, the installation quality of the all-resin carbon strip should be checked to ensure that the carbon strip is closely fitted to the substrate, without bubbles, wrinkles and other defects.

With the above steps, you can properly install the all-resin carbon strip and ensure that it achieves good reinforcement results. In actual operation, it is recommended to operate according to the specific product instructions and construction requirements.